top of page
Kuhnway banner_202505229-2.png

MA-P10~15 Pilot-operated Diaphragm Solenoid Valve

QUEEN SOLENOID VALVES

Discription

  • Pilot Operated solenoid valve with large flow capacity and low power consumption, only 5 watts.

  • Suitable for air, inert gases, water, kerosene, and light oils (below 50 cst).

  • Operating pressure range from 0.1 kgf/cm² to 16 kgf/cm², offering fast action and excellent durability.

  • Simple and convenient piping, suitable for both vertical and horizontal pipe connections without restrictions.

  • The "M10" marking indicates a waterproof coil with an IP65 protection rating.

  • The solenoid valve diaphragm is available in NBR, EPDM, or VITON materials.

Specifications

Model

​

(1) MA-P10-M10

(2) MA-P15-M10

Action mode

Normally closed

Voltage

​

AC 24, 110, 220, 380V 50/60Hz

DC 12, 24V​

Media

Air, gas, water, oil

Fluid temp.

-5~90°C

Fluid viscosity

Oil : 50 cst or less

Pressure range​

​

Air : 0.1~16  kgf/cm2

Liquid : 0.1~15 kgf/cm2​​

Connection size

​

(1) PT 3/8"

(2) PT 1/2"

Orifice

12 mm

Cv valve

2.6

Direction

Vertical / Horizontal

Valve material

BSBF

Seal material

​

​

NBR

EPDM

VITON

Coil type

Waterproof coil: IP65

Seal Material Characteristics

• NBR

∙ Temperature : -5~80°C

∙ Pros : Economical, widely used, with good oil and wear resistance.

∙ Cons : Unsuitable for polar solvents like nitro compounds, ozone, and ketones.

• EPDM

∙ Temperature : -10~130°C

∙ Pros : Resistance to polar solvents (alcohols, ketones, ethylene glycol) and mild acids/bases.

∙ Cons : Not suitable for gasoline, mineral oil, and aromatic hydrocarbons.

• VITON (FPM/FKM)

∙ Temperature : -10~120°C

∙ Pros : Stable, aging-resistant, and resistant to most oils and solvents.

∙ Cons : Costly, not recommended for ketones, esters, or nitro compounds.

Cautions

  • Before installation, please check whether the solenoid valve voltage is consistent with the power supply voltage.
    - AC voltage tolerance: ±10%
    - DC voltage tolerance: ±1%

  • If there are unclean impurities in the fluid, a filter should be installed to avoid reducing the service life and hindering the operation of the solenoid valve.

  • Please install the solenoid valve in the direction of the fluid.

  • The pilot solenoid valve needs a basic pressure to open

  • Not suitable for frozen fluids

Certificate

  • CE

bottom of page