MA-10~15 Diaphragm Type Solenoid Valve
QUEEN SOLENOID VALVES
Discription
-
Suitable for air, inert gases, vacuum (10 Torr), water, kerosene oil, and oil (Below 50 cst).
-
Diaphragm-operated pressure range from vacuum (10 Torr) up to 10kgf/cm², quick acting.
-
Can be mounted in vertical and horizontal position.
-
The M13 marking indicates a waterproof coil with an IP65 rating.
-
Model MA-10~15EP, voltage options : AC110V/DC24V common use.
-
The diaphragm can be selected from NBR, EPDM, or Viton.
-
The maximum pressure options are 10 kgf/cm²、15 kgf/cm² or 20 kgf/cm².
MA-15 Diaphragm Type Solenoid Valve with PT 1/2" port, ideal for general water application.
MA-10-M13 Diaphragm Type Solenoid Valve with PT 3/8" port and waterproof coil, ideal for general water application.
MA-15EP膜片式電磁閥，DC24V和AC110V共用輸入電壓，適合搭配一齊開放閥做消防控制使用
MA-15 Diaphragm Type Solenoid Valve with PT 1/2" port, ideal for general water application.
Specifications
Model
(1) MA-10-(M13)
(2) MA-15-(M13)
Action mode
Normally closed
Voltage
AC 24, 110, 220, 380V 50/60Hz
DC 12, 24V
* DC24V/AC110V common use
Media
Air, gas, vacuum, water, oil
Fluid temp.
-5~90°C
Fluid viscosity
Oil : 50 cst or less
Pressure range
Air, water, gas : 0~10 kgf/cm²
Oil : 0 ~ 7 kgf/cm²
Connection size
(1) PT 3/8"
(2) PT 1/2"
Orifice
12 mm
Cv valve
2.4
1.6 (M13)
Direction
Vertical / Horizontal
Valve material
C3771BE
Seal material
NBR
EPDM
Viton
Coil type
Iron case coil: IP54
Waterproof coil: IP65
Order Information
Seal Material Characteristics
• NBR
∙ Temperature : -5~80°C
∙ Pros : Economical, widely used, with good oil and wear resistance.
∙ Cons : Unsuitable for polar solvents like nitro compounds, ozone, and ketones.
• EPDM
∙ Temperature : -10~130°C
∙ Pros : Resistance to polar solvents (alcohols, ketones, ethylene glycol) and mild acids/bases.
∙ Cons : Not suitable for gasoline, mineral oil, and aromatic hydrocarbons.
• VITON (FPM/FKM)
∙ Temperature : -10~120°C
∙ Pros : Stable, aging-resistant, and resistant to most oils and solvents.
∙ Cons : Costly, not recommended for ketones, esters, or nitro compounds.
Cautions
-
Before installation, please check whether the solenoid valve voltage is consistent with the power supply voltage.
- AC voltage tolerance: ±10%
- DC voltage tolerance: ±1% -
If there are unclean impurities in the fluid, a filter should be installed to avoid reducing the service life and hindering the operation of the solenoid valve.
-
Please install the solenoid valve in the direction of the fluid.
-
Not suitable for freezing fluids.
Certificate
-
CE